Garmin GPSMAP 198C Sounder Manual do Utilizador descarregar pdf (Página 103)

GPSMAP 198C Sounder Owner’s Manual 97

APPENDIX > INSTALLING THE TRANSDUCER

Transom Mount Transducer

The following diagram is for mounting the transducer included with the GPSMAP 198C Sounder with transducer package. If the

transducer lead is too short, extension cables are available from your Garmin dealer. DO NOT cut the transducer lead or any part of the

transducer cable, as this will void your warranty. The cable cannot be spliced and connected to any existing (Garmin or non-Garmin)

transducer cables.

NOTE: DO NOT mount the transducer behind strakes, struts, ﬁttings, water intake, or discharge ports, or anything that creates air bubbles or

causes the water to become turbulent. It is important that the transducer is in clean (non-turbulent) water for optimal performance.

Do not mount transducer directly in the

path of the prop. The transducer can cause

cavitation that may degrade the boat's performance

and damage the prop.

Make sure that the transducer is

below water level when the boat

is on plane at high speed

Apply marine sealant to all

screw threads to prevent water

from seeping into the transom.

Mount the transducer cable cover

well above the waterline.

ansducer should extend 1/8" below

fiberglass hull or 3/8" below aluminum hull

Mount the transducer parallel with the bottom.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 125 126

Sem comentários

Garmin GPSMAP 198C Sounder Manual do Utilizador Página 103