ClassBDriveUnitInstallationInstructions 3
Notice
The reservoir is tted with a special cap that contains a breather hole. The
breather hole is sealed for transit and must be opened before operation.
The reservoir contains the hydraulic uid necessary for operation of the
drive unit, and it must be installed and prepared before installing any other
components. Do not attempt to move the cylinder rod until instructed.
You must rst select a mounting location before you can install the reservoir
(page 2).
1. Select fastening screws suitable for mounting the reservoir on a bulkhead
of your boat.
2. Choose a location on a bulkhead as far above the pump and cylinder as
possible and mark the pilot holes
➊
.
If needed, the device and mounting-hole dimensions are provided in the
appendix (page 7).
➌ ➍
➋
➊
3. Drill the pilot holes using a drill bit appropriate for the chosen screws.
4. Secure the reservoir to the bulkhead with the screws.
5. Remove the transit screw and seal
➋
from the cap.
Save the screw and seal for future use.
6. Using the included hydraulic oil, ll the reservoir to the maximum level
as indicated on the label.
7. Turn the valve from the OFF position
➌
to the ON position
➍
.
8. Extend the cylinder rod halfway, and check the oil level.
9. If necessary, add oil.
Notice
Do not disconnect the hydraulic hoses from the pump.
Bolts, washers, and nuts are provided to install the pump.
You must rst select a mounting location before you can install the pump
(page 2).
1. Make sure that the brush holders
➊
are accessible for service after
mounting the pump.
➋
➊
2. Mark the pilot hole locations
➋
.
If needed, the device and pilot hole dimensions are provided in the
appendix (page 7).
3. Drill the mounting holes using a drill bit appropriate for the mounting
surface and the mounting hardware.
4. Secure the pump to the mounting surface with the included hardware.
Notice
The cylinder rod movement must be limited by physical end stops to 12 in.
(305 mm) from fully retracted to fully extended. Failure to install steering
end stops will damage the drive unit.
Do not exceed the 5° angle at the extremes of the stroke (page 8). Exceeding
the 5° angle at the extremes of the stroke will damage the cylinder bearings
and the rod.
You must rst select a mounting location before you can install the cylinder
(page 2).
1. Install the mounting foot (page 3).
2. Install the tiller bolt (page 4).
The mounting foot is at the base of the cylinder.
Hardware is supplied to fasten the mounting foot to the mounting surface.
The supplied M8 bolts, washers, and nuts are suitable for mounting the
cylinder on a surface between .47 in. (12 mm) and .95 in. (24 mm) thick.
1. With the mounting foot in the chosen location, mark the locations of the
four mounting holes on the mounting surface.
(15 páginas)
(24 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais