
Garmin G1000 Cockpit Reference Guide for the Piper PA-46 Meridian
190-00764-02 Rev. A
Appendix
98
Flight
InstrumentsEICAS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
6)
Turn the system OFF and remove the SD card from the top card slot.
7)
Repeat steps 1 through 6 for the other display (PFD or MFD).
8)
Apply power to the system and press the ENT Key to acknowledge the startup
screen.
9)
Turn the large FMS Knob to select the AUX Page group on the MFD.
10)
Turn the small FMS Knob to select the System Status Page.
11)
Press the Display Database Selection Softkey to show active navigation
database information for each display (MFD1 DB, PFD1 DB, PFD2 DB). Verify
the correct active navigation database cycle information is shown for each
display.
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
Loading the Jeppesen Navigation Database as the Standby Navigation
Database
1)
With the system OFF, insert the SD card containing the new navigation
database version into the top card slot of the MFD.
2)
Verify that an SD card is inserted in the bottom slot of each display.
3)
Turn the system ON. A prompt screen is displayed.
4)
Press the YES Softkey. The navigation database is copied to the SD card in
the bottom card slot of the MFD.
5)
Press the NO Softkey. The display now starts in normal mode. Since the
database effective date is not yet valid, it should not be loaded as the
active database.
6)
Press the ENT Key to acknowledge the startup screen.
NOTE: During the synchronization process, version differences between
standby navigation databases will exist. This will result in the system display-
ing a ‘DB Mismatch’ alert for the standby navigation databases. This alert
will remain until the next power cycle.
7)
Turn the large FMS Knob to select the AUX Page group on the MFD.
8)
Turn the small FMS Knob to select the System Status Page.
Comentários a estes Manuais