Garmin TR-1 Manual de Instruções descarregar pdf

Cylinder and Bracket Mounting

Instructions

Honda 9.9 HP : 1987-2000

Honda 15 HP: 1987-2002

PN 906-1050-00

Page 1

TR-1 Gold

1 2 3 4 5 6 7 8

Resumo do Conteúdo

Página 1 - TR-1 Gold

Cylinder and Bracket Mounting InstructionsHonda 9.9 HP : 1987-2000Honda 15 HP: 1987-2002PN 906-1050-00Page 1TR-1 Gold

Página 2 - Figure 1

Page 2Parts:ITEM PART NUMBER QTY DESCRIPTION1 330-1051-00 1 NUT, STANDOFF2 130-1052-00 1 BRACKET, ROD EYE MOUNTING3 330-1003-00 1 PIN, STERN PIVOT4 38

Página 3 - Figure 3

Section 1. Installing the Cylinder Mounts.Tools Required: 9/32 inch or 7mm wrench10 mm wrench1/2 Inch wrench (at least one needs to be open end)Threa

Página 4 - Figure 4

Step 1: Rear NutsTip the motor all the way up. Remove the two rear nuts from the lower motor port side vibration isolation mounting shroud by loos-en

Página 5 - Figure 7

Step 3: Front ScrewRemove the forward nut from the lower motor port side vibration isolation mounting shroud by loosening the screw that comes into it

Página 6 - Figure 9

Page 6Figure 8Figure 9Figure 10Step 5: Mounting the ChannelPut a little thread lock on the ends of the three 6 mm Hex Cap screws (item 11) and instal

Página 7 - Figure 13

Page 7Step 8: Cylinder Rod EyePlace the Rod Eye (item 31) over the vertical pin in the rod eye mounting bracket (item 2) as shown. (Leave the cylind

Página 8 - Figure 14

Page 8Figure 15Step 10: Full Port and StarboardTurn the motor hard over to port. That will retract the cylinder rod into the cylinder. Check that t