Garmin Software Version 0857.09 Manual de Instruções descarregar pdf (Página 30)

Page 3-12 G1000 System Maintenance Manual - Hawker Beechcraft G58

Revision 3 190-01180-02

3.7.1 MFD & PFD SOFTWARE LOAD

IMPORTANT!

When replacing a display, it is REQUIRED to update the system files

with the new display in the MFD slot regardless of intended final

configuration, PRIOR to loading configuration files. Failure to do so could

result in loss of any existing calibration/configuration data.

a. Apply power to the G1000 by doing the following: Connect a ground power unit to the

external power receptacle, and turn on the ground power unit.

b. Turn on the L BAT MASTER, R BAT MASTER, and AVIONICS MASTER switches. At this

moment, all G1000 equipment is receiving power.

c. Pull the MFD and PFD circuit breakers.

d. Insert the loader card into the MFD top card slot.

e. While holding the ENT key on MFD, restore power by closing the MFD circuit breaker.

f. When the words

appear in the upper left corner of MFD, release

the MFD ENT key.

g. Press the MFD ENT key to acknowledge the following prompt (NOTE: A softkey labeled

YES appears in the lower right corner and may be used in lieu of the ENT key):

h. The following screen is displayed.

i. New software is loaded to MFD. When complete, the MFD starts in configuration mode

displaying the System Status page . Do not remove power.

j. Remove the loader card from MFD and insert it into the top card slot on the PFD. Repeat

Steps e through h for the PFD.

k. When PFD update is complete, it starts in the configuration mode. Do not remove power.

When complete, both displays should be in configuration mode, with the Loader Card

remaining in the top slot of PFD.

IMPORTANT!

For the rest of the software/configuration procedure, do not operate the

MFD while loading software or configuration files unless specifically

instructed to do so. A failed or cancelled load may result.

l. On PFD, verify on the SYSTEM CONFIGURATION PAGE that the following LRUs are

present. (status box is green, as shown below): MFD, PFD, GIA1, GIA2, GDL 69A and

GWX.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 78 79

Sem comentários

Garmin Software Version 0857.09 Manual de Instruções Página 30