
G1000 System Maintenance Manual - Hawker Beechcraft G58 Page 4-3
190-01180-02 Revision 3
4.3 MAINTENANCE INTERVALS
Table 4.1 below shows the systems and equipment installed by this STC that must undergo any
maintenance action and identifies the timeframe in which that activity should occur.
The previously approved Instructions for Continued Airworthiness defined under TCDS 3A16,
and identified in Table 1-1, remain valid and applicable for all other maintenance and ICA
aspects of the G1000 and GFC 700 systems. This STC does not remove or allieviate any of the
existing maintenance requirements for the Hawker Beechcraft G58 aircraft unless specifically
stated.
Table 4.1 - Maintenance Intervals
Item Description / Procedure Section # Interval
Visual Inspection
Complete visual inspection of
new equipment and wiring
4.3.1
Annual inspection
(in conjunction with existing
visual inspection requirements)
Electrical Bonding
tests
Conduct electrical bonding
checks of new LRUs and
Antenna
4.3.3
Annual inspection
(in conjunction with existing
visual inspection requirements)
Suspected lightning
strike to GA58
antenna
Inspect antenna and surrounding
structure to ensure there is no
structural damage where
lightning may have attached. If
there is visible damage to the
equipment, then it should be
replaced.
6.3 On Condition
GDU 1040 PFD Remove and Replacement
6.5
On Condition
GDU 1045 MFD Remove and Replacement On Condition
GMU 44
Magnetometer
Remove and Replacement 6.6 On Condition
GTS 820 Traffic
receiver
Remove and Replacement 6.1 On Conditon
GPA 65 Traffic
PA/LNA
Removal and Replacement 6.2 On Condition
GA 58 Antenna Remove and Replacement 6.3 On Condition
GRT 10 XM remote
control transceiver
Removal and Replacement 6.4 On Condition
GRC 10 XM remote
control
Replacement / Reconfiguration 6.4.1 On Condition
Comentários a estes Manuais