Garmin Software Version 0563.05 Guia do Utilizador Página 135

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 190
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 134
Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-08 Rev. A
8-9
SECTION 8 – FLIGHT PLANNING
For point-to-point planning, turn the
FMS
Knobs to
enter the identifier of the starting waypoint. Once
the waypoints identifier is entered, press the
ENT
Key to accept the waypoint. The flashing cursor
moves to the ending waypoint. Again, turn the
FMS
Knobs to enter the identifier of the ending waypoint
and press the
ENT
Key to accept the waypoint.
Or
:
For flight plan leg planning, press the
FPL
Softkey (at
the bottom of the display) and turn the small
FMS
Knob to select the desired flight plan (already stored
in memory), by number. Turn the large
FMS
Knob
to highlight the ‘LEG’ field and turn the small
FMS
Knob to select the desired leg of the flight plan, or
select ‘CUM’ to apply trip planning calculations to
the entire flight plan. Selecting ‘FPL 00’ displays the
active flight plan. If the active flight plan is selected,
‘REM’ is an available option to display planning
data for the remainder of the flight plan.
NOTE: The Page Mode must be set to MANUAL
to perform the following steps.
5)
Turn the large
FMS
Knob to highlight the departure
time (DEP TIME) field.
NOTE: The departure time on the Trip Planning
Page is used for preflight planning. Refer to the
Utility Page for the actual flight departure time.
6)
Turn the
FMS
Knobs to enter the departure time.
Press the
ENT
Key when finished. (Departure time
may be entered in local or UTC time, depending
upon system settings).
7)
Turn the
FMS
Knobs to enter the fuel flow. Press
the
ENT
Key when finished. Note that in automatic
page mode, fuel flow is provided by the system.
8)
The flashing cursor moves to the fuel on board field.
Turn the
FMS
Knobs to modify the fuel on board.
Press the
ENT
Key when finished. In AUTOMATIC’
mode, fuel onboard is provided by the entry made
in ‘GAL REM’ on the EIS System Page.
9)
The flashing cursor moves to the calibrated airspeed
field. Turn the
FMS
Knobs to enter a calibrated
airspeed. Press the
ENT
Key when finished.
10)
The flashing cursor moves to the indicated altitude
field. Turn the
FMS
Knobs to enter indicated
altitude. Press the
ENT
Key when finished.
11)
The flashing cursor moves to the barometric
pressure field. Turn the
FMS
Knobs to enter the
altimeter barometric pressure setting. Press the
ENT
Key when finished.
12)
The flashing cursor moves to the total air
temperature field. Turn the
FMS
Knobs to enter
the total air temperature. Press the
ENT
Key when
finished.
Vista de página 134
1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 189 190

Comentários a estes Manuais

Sem comentários