
Garmin G1000 Cockpit Reference Guide for the Piper PA-28-181 Archer
190-01460-00 Rev. A
Appendix
101
Flight
Instruments EIS
Nav/Com/
XPDR/Audio GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation Annun/Alerts Appendix Index
Loading the Jeppesen Navigation Database as the Standby Navigation
Database
The purpose of the Standby Navigation Database is to allow the loading of the
next cycle of the Jeppesen Navigation Database to the bottom SD card, prior to its
effective date. (The Jeppesen Navigation Database is available from Jeppesen seven
days prior to its effective date.)
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
1)
With the system OFF, insert the SD card containing the new navigation
database version into the top card slot of the MFD.
2)
Verify that an SD card is inserted in the bottom slot of the PFD and the
MFD.
3)
Turn the system ON. A prompt is displayed.
4)
Press the YES Softkey. The navigation database is copied to the SD card in
the bottom card slot of the MFD.
5)
After the navigation database files are copied to the bottom SD card, press
any key to verify, as instructed.
6)
After database verification is complete, press any key to continue as
instructed on the display.
7)
Press the NO Softkey. The display now starts in normal mode. Since the
database effective date is not yet valid, it should not be loaded as the
active database. The display now starts in normal mode. Do not remove
power while the display is starting.
8)
Press the ENT Key to acknowledge the startup screen.
9)
Turn the large FMS Knob to select the AUX Page group on the MFD.
Comentários a estes Manuais