Garmin Software Version 0858.09 Manual de Instruções descarregar pdf (Página 39)

G1000 System Maintenance Manual - Hawker Beechcraft G36 Page 3-21

190-01259-00 Rev. 5

3.11 Chartview Enable Procedure

NOTE

• The Chart Enable card can only enable Charts on one system (one

aircraft). A new Chart Enable card must be used for each aircraft.

• The required ChartView databases are subscription-based and are

to be procured by the installing agency directly from Jeppesen.

• The G1000 can only be configured for FliteCharts or ChartView but

not both. Performing this procedure will automatically disable the

FliteChart option.

a. Apply power to the G1000 system.

b. Pull the PFD and MFD circuit breakers.

c. Insert the Chart Enable card, 010-00330-50 in the upper slot of the PFD.

d. While holding the ENT key on the PFD and MFD restore power to the displays.

e. When the words

appear in the upper left corner of the

displays, release the ENT key.

f. On the PFD, go to the System Upload page.

g. Activate the cursor and rotate the small FMS knob to activate the drop down menu

and select CONFIGURATION FILES in the AIRFRAME field. Press ENT.

h. Rotate the small FMS knob to activate the drop down menu and select ENABLE

CHARTVIEW in the FILE field. Press ENT.

i. Verify there is a check mark in the box in the configuration column for AIRFRAME.

j. Press the LOAD softkey.

k. Monitor the status of the upload. When the upload is finished Complete and Pass is

displayed. Press ENT.

l. De-activate the cursor.

m. Power down the system and remove the ChartView Enable card from the PFD.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 78 79

Sem comentários

Garmin Software Version 0858.09 Manual de Instruções Página 39