Garmin Software Version 0858.09 Manual de Instruções descarregar pdf (Página 41)

G1000 System Maintenance Manual - Hawker Beechcraft G36 Page 3-23

190-01259-00 Rev. 5

3.13 Aircraft Registration Number Entry

NOTE

The large FMS knob changes Groups and the small FMS knob changes

Pages within a Group.

NOTE

If aircraft has a Garmin GTS 8XX Traffic System installed, ensure GTS

8XX system configuration is loaded prior to registration entry for

transponder (See Section 3.7.3).

a. Remove power (if applied) from PFD by pulling the PFD circuit breaker.

b. While holding the ENT key on the PFD, restore power by closing the PFD circuit

breaker.

c. When the words INITIALIZING SYSTEM appear in the upper left corner of the PFD

release the ENT key.

d. Rotate the outer FMS knob to activate the GTX group, then rotate the small FMS

knob to select the TRANSPONDER CONFIGURATION page on PFD.

e. Ensure that the ADDRESS TYPE is US TAIL under the SET and XPDR ACTIVE

columns.

f. Ensure that the FLIGHT ID TYPE is SAME AS TAIL under the SET and ACTIVE

columns.

g. Activate the cursor and highlight the MODE S ADDRESS field. Use the small/large

FMS knob to enter the aircraft registration number.

h. Once the correct registration number is entered, press the ENT key to configure the

transponder.

i. Observe the status window and press the ENT key on PFD to acknowledge the OK

prompt once configuration is complete.

3.14 Clearing Default User Settings

a. Remove power from PFD and MFD.

b. While holding the CLR button on PFD, re-power PFD.

c. When prompted to clear user settings select the YES softkey.

d. Repeat steps a-c for MFD.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 78 79

Sem comentários

Garmin Software Version 0858.09 Manual de Instruções Página 41