Garmin Software Version 0858.09 Manual de Instruções descarregar pdf (Página 57)

G1000 System Maintenance Manual - Hawker Beechcraft G36 Page 6-3

190-01259-00 Rev. 5

6.4 GRT 10 XM Remote control transceiver

Removal:

1. Gain access to GRT 10 under glareshield on copilot side of cockpit. Refer to the “GRT

10 Equipment Install, Hawker Beechcraft G36” drawing listed in Table 1.1.

2. Disconnect the electrical connector.

3. Remove the three mounting screws that hold the unit to the installation bracket.

Reinstallation:

1. Inspect the connector for damaged pins.

2. Reattach the unit to the mounting bracket reusing exiting hardware.

3. Reconnect the electrical connector and ensure it is locked in place. If GRT or GRC is

replaced, system must be reconfigured in accordance with instructions in Section 3.7.4.

6.4.1 GRC 10 Remote Control Battery Replacement

If the unit does not turn on, or the battery level indicator on the display shows no bars, replace

the batteries. To replace the batteries in the GRC 10 Remote Control, remove the back cover

of the remote. Insert two fresh AA batteries with the orientation as shown in the diagram in the

battery compartment. Both batteries should be replaced with fresh batteries at the same time.

Figure 6.1 - Battery Compartment

WARNING

Do not use lithium batteries in the GRC 10.

NOTE

Remove batteries when the GRC 10 is stored for extended periods.

CAUTION

When replacing batteries, use only new or fully charged batteries. Do not

mix new and old batteries as this can cause battery leakage and

damage to the unit. Do not mix battery types (i.e. rechargeable with non-

rechargeable).

CAUTION

Remove batteries if the GRC 10 will not be in use for several months.

Storing batteries in the unit for prolonged periods may result in leakage

and damage to the battery compartment.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 78 79

Sem comentários

Garmin Software Version 0858.09 Manual de Instruções Página 57