Garmin Software Version 0858.09 Manual de Instruções descarregar pdf (Página 73)

G1000 System Maintenance Manual - Hawker Beechcraft G36 Page 8-7

190-01259-00 Rev. 5

e. Transmit for a period of 35 seconds while monitoring GPS 1 signal strength levels.

f. During the transmit period, verify that the GPS “INTEG” flag does not come into view

on the PFD and verify that GPS 1 does not lose a 3-D navigation solution on the

MFD.

g. Repeat steps e and f and re-transmit while monitoring GPS 2 signal levels on the

MFD.

h. Repeat steps d through g for each of the following frequencies:

• 121.175 MHz

• 121.200 MHz

• 131.250 MHz

• 131.275 MHz

• 131.300 MHz

i. Repeat steps d through h for the No. 2 COM transceiver (GIA2).

j. On the MFD, select the AUX – SYSTEM SETUP page.

k. Under the COM CONFIG field, change the COM channel spacing from 25 kHz to

8.33 kHz.

l. Go back to the AUX – GPS STATUS page.

m. Select 121.185 MHz on the No. 1 COM transceiver.

n. Transmit for a period of 35 seconds while monitoring GPS 1 signal strength levels.

o. During the transmit period, verify that the GPS “INTEG” flag does not come into view

on the PFD and verify that GPS 1 does not lose a 3-D navigation solution on the

MFD.

p. Repeat steps n and o and re-transmit while monitoring GPS 2 signal levels on the

MFD.

q. Repeat steps n through p for each of the following frequencies:

• 121.190 MHz

• 130.285 MHz

• 131.290 Mhz

r. Repeat steps n through q for the No. 2 COM transceiver (GIA2).

s. On the MFD, select the AUX – SYSTEM SETUP page and change the COM channel

spacing back to 25 kHz.

Continue to the VOR/LOC/GS Test.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 79

Sem comentários

Garmin Software Version 0858.09 Manual de Instruções Página 73