
Page 4-4 G1000 System Maintenance Manual - Hawker Beechcraft G36
Rev. 5 190-01259-00
Item Description / Procedure Section # Interval
GRC 10 XM remote
control
Replacement / Reconfiguration
6.4.1
On Condition
Battery replacement On Condition
Synthethic Vision
/Pathways
Reactivation 3.10
On Condition / after GDU
replacement
GTX 33ES
Tranponder with
Extended Sqitter
Functionality **
Removal and Replacement 6.7 On Condition
Transponder test
(required for compliance with
Title 14 of the Code of Federal
Regulations (14 CFR) §§ 91.411
and 91.413)
7.1 Every 24 Calendar months
4.3.1 Visual Inspection Requirements
In conjuction with existing Annual visual inspection requirements, conduct the following:
• Inspect all new appliances, antennas, and electrical connectors and coax connectors for
corrosion or other defects.
• Check the integrity of all shield block ground attachments to the harness connector as
well as integrity of the individuals shields.
• Inspect all exposed wiring for chaffing, damage, proper routing and security of
attachment.
• Signs of corrosion on equipment, racks, aircraft structure relied upon for ground, and
connectors, backshells, wire attachment.
• Conduct a visual inspection of the antennas and mounting. Verify there are no cracks in
the antenna, no deformation in the mounting structure, and that all sealing fillets around
the antennas are in good condition.
• If the antenna is broken, cracked, dented, etc. then it must be replaced.
• If the attachment is not secure, re-work the installation and complete electrical bonding
test based on installation requirements.
• In the event the antenna seal shows sign of damage or decomposition, re-seal and
complete the Electrical bonding test to installation requirements.
4.3.2 Coax Cable Maintenance
CAUTION
fter any maintenance or modification is made to the GTS 820 TAS
cables such as replacing a connector or entire cable, some important
considerations must be made.
Comentários a estes Manuais