
Page 5-4 G1000 System Maintenance Manual - Hawker Beechcraft G36
Rev. 5 190-01259-00
• Ensure that LRU part number is compatible
with Card Loader. Refer to the General
Arrangement Drawing 005-00620-06 and to
Section 3.6 of this document.
• Replace LRU.
Software File Mismatch Alert appears in lower
right corner of PFD when started in normal mode:
• Ensure that proper software file part number
and version were loaded to LRU. Refer to the
General Arrangement Drawing 005-00620-06
and to Section 5.4.
• Check and ensure that correct Card Loader
was used during load process. Refer to the
General Arrangement Drawing 005-00620-06.
• Reload software to LRU.
5.4 GRT 10 / GRC 10 XM Remote control troubleshooting
Problem Action
GRT 10 not found
• Verify GRT 10 is receiving power.
• Verify the RF pairing ID entered into GRC 10 is correct.
GRT 10 connection lost
• Verify that the GRC 10 is in RF range of the GRT 10.
• Verify GRT 10 wiring and power.
GDL 69A not found
• Verify wiring between GDL 69A and GRT 10.
• Verify GDL 69A is powered on.
GDL 69A connection is lost
• Verify wiring between GDL 69A and GRT 10.
• Verify GDL 69A is powered on.
GRC 10 will not power on.
• Verify batteries are installed.
• Install fresh batteries. See Section 7.3.
5.5 System Communication Hierarchy
The following criteria must be satisfied to be able to perform the desired operation:
Desired Operation Criteria for Success
Load Software to MFD or PFD Displays
• SW Loader Card must be inserted in top slot
for each display to be loaded.
• CLR & ENT keys must be held during power
up of display.
• Power on only one display at a time during
software loading.
Load AIRFRAME, SYSTEM, MFD, PFD and
MANIFEST configuration files to MFD and PFD
• SW Loader Card must be inserted in top slot
of PFD.
• PFD and MFD must be powered on.
• PFD and MFD must have correct software.
Load Software/Configuration files to GIA 63Ws
• SW Loader Card must be inserted in top slot
of PFD.
Comentários a estes Manuais